The Rock Rebar
Rock reinforcement has been developed especially for
harsh environments, such as dams and road bridges. It is made of volcanic rock
called basalt. Magma in the center of the Earth is basalt. Does not corrode.
Basalt rod is made of basalt continuous filament and epoxy polymers. Adhesion
to concrete is mainly an area of sand, but
there is a spiral "thread." Basalt filaments are made by the
fusion of crushed stone of volcanic basalt with a mixture of specific minerals
to 1700 degrees Celsius for 6 hours. The material is extracted from platinum
rings for the warm white special fiber cools. Fresh fibers in hexagonal channels
may results in an elastic structure significantly stronger than steel or
fiberglass. The Rock reinforcement fiber consists of 80% and 20% resin. Basalt
is nontoxic and inert. The production process generates no waste on the
environment and is not toxic for use or recycling.
He did not force loose in a fire situation the house (it
can take 600 degrees C quite happily). It is also naturally resistant to UV
exposure.
The tensile strength of continuous basalt fiber is about
twice as E-glass fibers and the modulus of elasticity is approximately 15-30%
higher. Basalt fibers in an amorphous state have a higher chemical stability of
glass fibers. When exposed to water at 70degrees C (158 "F), basalt fibers
retain their strength of 1,200 hours, while the glass fibers that make 200
hours.
Roca frame is about 2.5 times stronger (tensile) steel
bars and 60 series of the same diameter. The coefficient of thermal expansion
is very similar to concrete (when the steel is very different). Roca frame is
approximately one third the weight of steel and since it is 2.5 times stronger
than steel and its strength to weight ratio is 7.5 times better.
Rock and rebar has a strong power, and drew very little.
It has a very low modulus of elasticity than steel. If the subject is beyond
spec, then it will break rather than stretch. Positioning the plate design
needs to do this. The structural design is considered as "tensile
modulus". Proper structural design, brushed steel does not have anywhere
near the force required to break it.
Contact Us:
FRP Distributors Inc.
14540 – 115 Avenue
Edmonton, Alberta, Canada T5M
3B9
Toll Free: 1-877-455-5105
Main Phone: 1-780-455-5105
Main Fax: 1-780-455-5140
No comments:
Post a Comment